Dediprog Serial Flash Programmers

Production Programmers:


Founded in 2005 in Taiwan and Shanghai base was established in 2010. DediProg is a company aiming at the solutions of IC programming of EEPROM, SPI Flash,NOR Flash, NAND FLASH, Microcontroller, eMMC,CPLD and other programmable devices.

Model 1: SF100

The SF100 is a high speed "In System Programming" programmer to update the SPI Flash soldered on board or Freescale MCU using Ezport. The programmer is easily controlled by the computer DediProg Software through the USB bus offering friendly interface and powerful features to users.

Features:

  • USB Interface
  • Signal conflict protections
  • Update Serial Flash soldered on board with application powered or not
  • Control Application, controller reset and MOSFET isolation status
  • Update the internal Flash of Freescale MCU using the Ezport (MCF5223,MCF5221,MCF5213) or the external SPI Flash of Freescale MCU using the SBF interface (MCF5445, MCF5227)

Model 2: SF600

The SF600 is a high speed "in System Programming" programmer to update the SPI Flash soldered on board (In Circuit Programming) or in the socket adaptor (Off line programming). The programmer is easily controlled by the computer DediProg Software through the USB bus offering friendly interface and powerful features to users. SF600 combines the advantages of SF100 with additional improvements:- High speed USB - Higher SPI performances - Support Single, Dual and Quad IO (ISP mode only).

Features:

  • USB High speed and high SPI performance, support up to 1Gb SPI Flash
  • In circuit Programming: Program on board SPI Flash
  • Off line Programming: Program SPI Flash in the socket
  • Support Single, Dual and Quad IO serial communication (new serial Flash protocol)
  • Program two Serial Flash memories
  • Start button feature: Can do Batch function in USB mode
  • Signal conflict protections

2021 © Uchi Embedded Solutions. ALL Rights Reserved.